[. . . ] Register your product and get support at
www. philips. com/welcome
SDV7220/12
User manual
1 Important
Safety Recycling
4 4 4 5 5 6 6 7 7 7 8 8 9 9 10
2 YourSDV7220/12
Overview
3 Get started
Installation
4 SetuptheSDV7220/12
Set up on the table Assemble antenna and stand Mount on the wall Set up a digital tuner with this antenna
5 Frequently asked questions 6 Warranty and Service 7 Glossary
EN
3
English
Contents
1 Important
Safety
This manual contains important information about the Philips indoor television antenna. [. . . ] It is important for the antenna to have an unobstructed path to the transmitter. For best results, ensure the antenna faces the location of the transmitter.
Note · Choose a location near a window which gives the
antenna a clear view of the transmitter.
Note · Place the antenna away from the metal surface to avoid
interference.
ConnecttotheTV
1
2
Connect one end of the UHF antenna coaxialcabletotheamplifier. Connectoneendoftheamplifiercoaxial cable to the TV receiver.
6
EN
4 Set up the SDV7220/12
Set up on the table
1
The antenna can be used with or without the included stand as below.
1
Unwrap the stand from the tablet of antenna.
2
Position the stand to the notches of the antenna.
3
Slidethestandtofixitontheantenna.
2
Slide the gain control switch of the amplifiertowardsthemax. position.
14
Tip · To disassemble the stand, reverse the assembly
procedure.
Note · It is possible to slide the gain control switch towards
themin. positionorremovetheamplifierforbest reception.
EN
7
English
Assemble antenna and stand
Mount on the wall
1
Mount two wood screws into the wall with 80mm (3. 149") of center distance.
Tip · It is possible to slide the gain control switch towards
themin. positionorremovetheamplifierforbest reception.
Set up a digital tuner with this antenna
2
Plug the plastic bracket into two notches on the rear housing, then push it up to lock in.
b
You can install available channels with the digital TV tuner. Ensure the antenna has set up properly before the tuner can receive viewable channels. There are two ways to connect the antenna to the TV: · Connect the antenna to a digital tuner. If the signal strength is good enough, the channels can be memorized in the tuner automatically . Ensure the signal strength is good enough before you install the channels with the tuner.
a
3
a
Attach the plastic bracket to the wood screws on the wall.
b
4
Slide the gain control switch of the amplifiertowardsthemax. position.
14
8
EN
5 Frequently asked questions
Can this antenna work with Analogue transmissions?Yes, this antenna can receive analogue television broadcasts in the UHF bandwidths. [. . . ] HDTV is digitally broadcast; the earliest
10 EN
Specifications are subject to change without notice ©2011KoninklijkePhilipsElectronicsN. V. [. . . ]